Bradley, 2905-287300, 2905, Sensor Hand Dryer, Surface-Mounted 110-120Volt, 13.6amps, 60HzProduct Materials:COVER: 5 ⁄64' (1.9mm) thick steel one-piece cover with white epoxy coating. Cover fixed to the base with four Allen-head screws.MOTOR: durable, maintenance-free shaded pole motor with safety thermostat and self-resetting thermal cut-off at 266ºF (130ºC). PP UL94-V0 with single inlet fan wheel.HEATING ELEMENT: waved wire NiCr 40 heating element that incorporates a self-resetting thermal cut-off at 158ºF (70ºC).ELECTRONIC CONTROL: two distances (15/25 cm) IR electronic detection sensor with zamak air outlet grill.BASE PLATE: thermoplastic ABS UL 94-V0 base and single-inlet centrifugal scroll fan; with four diametr 5 ⁄16' (8mm) holes for wall mounting.Installation:Verify all Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated circuit and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud.Operation:Place hands 3'−6' below air outlet grill to activate air flow. Dryer will stop two seconds after hands are removed from air flow.Guide:Surface-mounted hand dryer shall be fabricated from one-piece 5 ⁄64' (1.9mm) thick steel. Cover shall have a white epoxy coating. Back base shall be fireresistant plastic ABS UL 94-V0. Dryer shall be fitted with an infrared electronic sensor, zamak air outlet grill and shaded pole motor with safety thermostat and self-resetting thermal cut-off at 266ºF (130ºC). Dryer shall operate at 60 dB while delivering 194 CFM of air at 125.6°F (52ºC) and 4,181 LFM during user-controlled drying cycle. Dryer shall have a total power of 1,640 W (2.2 Hp) with a consumption of 13.6 A (2905-2873).Overall dimensions: 117 ⁄8'H x 101 ⁄16'W x 5½'D (302mm x 256mm x 140mm).Weight: 9.8 lb (4,45 kg).