Bradley, 2903-280000, 2903, Sensor Hand Dryer, Surface-Mounted 110-120Volt, 16amps, 60 HzProduct Materials:COVER: 1/4' (6 mm) thick one-piece cast iron with white porcelain enameled coating. Cover fixed to the base plate with two vandal-resistant lock screws and lock with special key wrench.NOZZLE: chrome-plated zamak. Nozzle is fixed.MOTOR: universal-type protected by a 4-amp fuse with sealed self-lubricated ball bearings. Aluminum centrifugal turbine with double symmetrical inlet. Fireproof plastic UL 94-VO scroll fan.HEATING ELEMENT: undulated nicrom with a safety thermostat.ELECTRONIC CONTROL: electronic infrared detection sensor is adjustable (6'–10'). Switch-off delay is two seconds maximumBASE PLATE: 1 ⁄8' (3 mm) thick aluminum, with four 5 ⁄16' (8mm) holes for wall mountingInstallation:Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated circuit and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud.Operation:Place hands 3'–6' below nozzle to activate air flow. Dryer will stop two seconds after hands are removed from air flow.Guide:Surface-mounted hand dryer shall have a thick cast iron cover with white porcelain enameled coating and aluminium back base. Hand dryer shall be fitted with a fixed chrome-plated zamak nozzle, infrared electronic control and universal-type motor with resilient mounts and sealed, lubricated ball bearings. Dryer shall operate at 70 dB while delivering 290 CFM of air at 128ºF (53ºC) and 5,512 LFM velocity during user-controlled drying cycle. The dryer shall have a total power of 1,850 W (2903-28) or 2,250 W (2903-28CE) with a consumption of 16 A (2903-28) or 10 A (2903-28CE). Overall dimensions: 10'H x 11-1 ⁄8'W x 8-1/2'D (254mm x 283mm x 216mm). Weight: 23.35 lb (10.6 kg).