Push-On Hose Mender Brass
Push-On Hose Mender Brass
Dixon Valve, 1' Push-On Hose Mender BrassSpecifications:Number of Barbs: 3Barb Length: 1.50'Installation:Assembly Instructions:1. Trim hose end with smooth square cut.2. Lubricate either push-on fitting, hose or both.3. Insert push-on fitting into hose until first barb is in hose.4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.Instructions:Disassembly instructions:1. Leaving push-on fitting in place, make a 1' cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.Note:No hose clamps or ferrules are neededSafety notes:Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.Lok-On fittings will properly grip Lok-On hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.WARNING: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling. ... Show More Show Less