Cecomp Electronics, APD 5393 D, IsoSplitter® Strain Gauge Amplifier/Signal Splitter 1 Strain Gauge Input to 2 Isolated DC Outputs, 9-30 VDC, 10-32 VAC PowerFeatures:One Input to Two Outputs with Full IsolationZero and Span Output Calibration PotentiometersFull 1200 V Input / Output / Power IsolationInput and Output LoopTracker® LEDsOutput Test Button for Each ChannelBuilt-In Loop Power Supplies for Sink/Source I/OApplications:Split, Convert, Boost, and Rescale Process SignalsSplit Process Signals for Control and ValidationInterface a Process Signal with Multiple Panel Meters, PLCs, Recorders, Data Acq., DCS, & SCADA SystemsThe APD 5393 D IsoSplitter accepts a strain gauge, bridge, or load cell input and provides two optically isolated DC voltage or current outputs that are linearly related to the input. The input range and each output range are independent and can be specified as required. This provides an economical solution when one signal must be sent to two different devices.Typical applications include isolation, output splitting, output device separation and redundancy (i.e. to prevent failure of the entire loop if one device fails), or a combination of these. The input signal is filtered, amplified, split, and then passed through an opto-coupler to the output stages. Full 4-way isolation (input, output 1, output 2, power) make this module useful for ground loop elimination, common mode signal rejection, and noise pickup reduction.I / O Sink / Source Versatility Standard on the APD 5393 D is an adjustable excitation supply for the input channel and 20 VDC loop excitation supplies for each output channel. The output power supplies can be selectively wired for sinking or sourcing allowing use with any combination of powered or unpowered milliamp I/O devices.LoopTrackerAPI exclusive features include three LoopTracker LEDs (green for input, red for each output) that vary in intensity with changes in the process input and output signals. These provide a quick visual picture of your process loop at all times and can greatly aid in saving time during initial startup and troubleshooting.Output Test An API exclusive feature includes output test buttons for each channel to provide a fixed output (independent of the input) when held depressed. A test button is provide for each output channel. The output test greatly aids in saving time during initial startup and/or troubleshooting. The test output level for each channel is potentiometer adjustable from 0 to 100% of the output span. Terminals are provided to operate the test functions remotely for each channel. This also allows use as a remote manual override to provide a temporary fixed output if desired.